|L. A. Ornamental & Rack Corp
3708 NW 82nd Street
Miami, Florida 33147
|About Us | Contact Us | Our Policies | FAQ | Manufactures | Links |
Copyright Protected 2004-2008 - L. A. Ornamental & Rack Corp. All rights reserved. No part of this site can be reproduced in any form
or by any means, electronic, mechanical, photocopying, or otherwise without prior written consent of L. A. Ornamental & Rack Corp.
3708 NW 82nd Street Miami Florida 33147, Office: 305-696-0419 Fax: 305-696-0461 E-Mail: LAOrnamental@Aol.com
|The Model Linear EXA-2000 Directional Remote Antenna is designed to enhance the radio range of Linear's receivers. This
antenna can be connected to the F connector on many Linear receivers to improve their range when they must be located in
poor signal reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-2000 can be mounted
either vertically or horizontally. NOTE: Generally, the higher the antenna is mounted above ground level, the better the radio
range will be. The EXA-2000 is a 1/2 wave, center fed, antenna composed of two parts: an antenna assembly with a ten-foot,
75-ohm coaxial cable with an F connector and two mounting brackets. The cable connects to the F connector on the receivers.
If the antenna must be mounted further than ten feet from the receiver, an additional extension cable of 15 feet may be used for
a maximum cable run of 25 feet. Because of the cable resistance, the performance of the EXA-2000 may be degraded by using
more than 25 feet of cable. Features Paintable PVC housing Includes 10 feet of coax Directional remote antenna Two mounting
brackets included 21" W x 5" H x 1.5" D
|Linear EXA-1000 Omni-directional Remote Antenna is designed to enhance the radio range of Linear’s receivers. This antenna
can be connected to the F connector on many Linear receivers to improve their range when they must be located in poor signal
reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-1000 can be mounted in a variety
of ways. A 2-inch U-bolt is supplied for post or pipe mounting, or the U-bolt holes in the Base Plate can be used to screw the
antenna to a wall or vertical wood brace or beam.
The EXA-1000 is a 1/2 wave, center fed, vertical antenna composed of three parts: an Antenna assembly with an F connector
attachment; a Base Plate assembly with radial mounting provisions; and a five-foot, 75-ohm coaxial cable. The cable connects
to the antenna base on one end and the receivers F connector on the other. If the antenna must be mounted further than five
feet from the receiver, an extension cable of up to a maximum of 25 feet may be used instead of the five foot cable supplied.
Because of the cable resistance, the performance of the EXA-1000 may be degraded by using longer than a 25 foot cable.
|Features: EXA 1000 • EXA 2000
Compatible with all Linear receivers
with Type F antenna connector
•Receives signals in 288 to 320 MHz
•Omni-directional remote antenna
•Includes 5 feet of coax
•U-bolt for post mounting
•3” W x 19.5” H x 6” D
•Order number: AAE00198
|Remote antenna kit for receivers equipped with a Type "F" antenna connector, whip antenna, bracket,
and 15-foot coax cable included.
|Linear 106604: Local Antenna 8-inch solid wire whip antenna with Type "F" connector and soft plastic
connector boot DRQP 1-channel Gate Receiver 109920 1-channel 110V Gate Receiver 302101 2-channel
Heavy Duty Gate Receiver SMDRG 1-channel Gate Receiver MDRG 1-channel Gate Receiver