L. A. Ornamental & Rack Corp 3708 NW 82nd Street Miami, Florida 33147 Office: 305-696-0419 Fax: 305-696-0461 |
About Us | Contact Us | Our Policies | FAQ | Manufactures | Links | Copyright Protected 2004-2008 - L. A. Ornamental & Rack Corp. All rights reserved. No part of this site can be reproduced in any form or by any means, electronic, mechanical, photocopying, or otherwise without prior written consent of L. A. Ornamental & Rack Corp. 3708 NW 82nd Street Miami Florida 33147, Office: 305-696-0419 Fax: 305-696-0461 E-Mail: LAOrnamental@Aol.com |
Linear EXA-1000 Omni-directional Remote Antenna The Model EXA-1000 Omni-directional Remote Antenna is designed to enhance the radio range of Linear's receivers. This antenna can be connected to the F connector on many Linear receivers to improve their range when they must be located in poor signal reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-1000 can be mounted in a variety of ways. A 2-inch U-bolt is supplied for post or pipe mounting, or the U-bolt holes in the Base Plate can be used to screw the antenna to a wall or vertical wood brace or beam Product Number: AAE00198 |
Linear EXA-2000 Directional Remote Antenna The Model EXA-2000 Directional Remote Antenna is designed to enhance the radio range of Linear's receivers. This antenna can be connected to the F connector on many Linear receivers to improve their range when they must be located in poor signal reception locations. Usually an increase of 20-30% range can be expected. The versatile EXA-2000 can be mounted either vertically or horizontally. Product Number: AAE00331 |
Linear AP-4 Gate Access Receiver Ideal for gated communities, parking facilities, and industrial sites. Easy to set-up and use — up to 480 remotes can be programmed with a few keystrokes. Easy to add, suspend, and delete transmitters through programming mode — no transmitter dip switches to set. Supports 480 block coded transmitters or 238 individual ransmitters/wireless keypad entry codes. Supports one fully supervised safety edge transmitter. |
Linear AP-5 Access Controller Dual-portal access control system, built-in radio receiver, supports 480 block coded transmitters or 238 individual transmitters/wireless keypad entry codes and six MGT obstacle transmitters, three relays, programmable access or obstacle output Product Number: ACP00953 |
Linear AM-RPR Remote Proximity Receiver The Model AM-RPR Remote Proximity Receiver is designed for use with Linear's access control systems. The AM-RPR functions as a remote device that supplies localized radio reception. In a typical installation, the AM-RPR would be mounted in a plastic single-gang electrical box next to the controlled opening. When the user requires access, their transmitter must be activated within three inches of the AM-RPR faceplate. The ultra-short range of the AM-RPR allows placement of a unit by each controlled opening without the possibility of the transmitter being detected by the wrong receiver Product Number: ACP00560 |
Linear AM-PC Proximity card The Model AM-PC Proximity Card is a Wiegand format proximity type access control card with a slot for attaching to a key ring, use with AM-PR proximity reader. Product Number: ACP00739 |
Linear AM-PT Proximity Tag The Model AM-PT Proximity Tag is a Wiegand format proximity type miniature access control tag with a slot for attaching to a key ring, use with AM-PR proximity reader Product number: ACP00742 |
Linear AM-PR Proximity Reader The Model AM-PR Proximity Reader is designed for use with Linear's access control systems. This close-range, reader works with either proximity tags or proximity cards. The AM-PR is rugged, rated for extreme weather, and vandal resistant. Product Number: ACP00740 |
Linear AM-CRI Card Reader The AM-CRI card reader interface is designed for use with Linear's access control systems. The interface will support one or two 26-bit or 31-bit Wiegand input devices. If the readers used have a hold or buffer connection, two readers may be used to the AM-CRI. If the readers do not have a hold or buffer connection, one reader may be used with the AM-CRI. Usually mounted near the readers, the AM-CRI interface connects to the control unit through a PBUS cable. Each reader connects to the AM-CRI through a six-wire (one LED in reader) or seven wire (two LEDs in reader) cable |
Linear AM-RRR Remote Radio Receiver The Model AM-RRR Remote Radio Receiver is designed for use with Linear's access control systems. The AM-RRR functions as a remote device that extends the radio range or supplies localized radio reception. Product Number: ACP00500 |
Linear RGR Remote Genie Receiver Radio receiver for outdoor applications, receives signals from Linear GT-30/GT-31 transmitters and many Genie transmitters, connects to AM/II, AM-3, AE-1, AE-2, AE-1000, or AE-2000 access controllers, metal case, antenna included Product number: ACP00745 |
Linear WOR Wiegand Output Receiver Access control interface for Linear block coded transmitters, adds a facility code to the transmitter data, and sends the information to the Wiegand input of an access control panel via a 5-wire connection, waterproof metal enclosure Product Number: ACP00727 |
Linear CCM-1 Color Camera The Model CCM-1 Color Camera mounts inside AE-100, AE-500, AE1000Plus and AE2000Plus commercial access controllers to provide color video of the access control visitor. Product number: ACP00904 |
Linear RE-BWC-1 Black and White Camera The Model RE-BWC1 Black & White Camera mounts inside RE-1N or RE-1SS residential telephone entry systems to provide black and white video of the entry system visitor. Built-in infrared illuminators help to light the subject in low-light conditions. Product number: ACP00886A |
Linear CCM-2 Color Camera The Model CCM-2 Color Camera mounts inside RE-2 Nickel or Stainless Steel commercial access controllers to provide color video of the access control visitor. Product number: ACP00936 |
Linear CPDM-1 Video Modulator for Access Cameras The Model CPDM-1 Digital Modulator converts any baseband NTSC video and audio signal to a selected UHF or Ultraband CATV channel. A quartz crystal reference oscillator and PLL circuitry ensure drift-free performance. The modulator can be used to convert video signals from Linear's access control systems to UHF or CATV signals that can be viewed on a standard television set at the installation. |
Linear Trim Ring TR-100 The Model TR-100 Trim Ring is designed for recess mounting the Model AE-100 Commercial Telephone Entry System. The flush-mount trim ring attaches to the wall studs or custom framing. The AE-100 attaches to the mounting ring. |
Linear Trim Ring TR-500 The Model TR-500 Trim Ring is designed for recess mounting the Model AE-500 Commercial Telephone Entry System. The flush-mount trim ring attaches to the wall studs or custom framing. The AE-500 attaches to the mounting ring. |
Linear Trim Ring TR-1000 The Model TR-1000 Trim Ring is designed for recess mounting the Model AE1000Plus Commercial Telephone Entry System with Access Control. The flush-mount trim ring attaches to the wall studs or custom framing. The AE1000Plus attaches to the mounting ring. |
Linear Trim Ring TR-2000 The Model TR-2000 Trim Ring is designed for recess mounting the Model AE2000Plus Commercial Telephone Entry System with Access Control. The flush-mount trim ring attaches to the wall studs or custom framing. The AE2000Plus attaches to the mounting ring |
Linear Trim Ring RT-RE2N The Model TR-RE2N Trim Ring is designed for recess mounting the Model RE-2N Residential Telephone Entry System. The flush-mount trim ring attaches to the wall studs or custom framing. The RE-2N attaches to the mounting ring. |
Linear Trim Ring TR-RE2SS The Model TR-RE2SS Trim Ring is designed for recess mounting the Model RE-2SS Residential Telephone Entry System. The flush-mount trim ring attaches to the wall studs or custom framing. The RE-2SS attaches to the mounting ring. |
|
BFT Cell Phone Entry with Keypad up to 1000 User -- Open Your Gate From any where in the world Click here |